Any Mach4 users with a PM940 or similar?

[rodjava]

I'm researching different controllers other than Mach3.

I have the 940 cnc vs with the nmotion cnc controller. I'm curious what it takes to
adopt mach4 with my existing setup.

Rod in San Francisco

 

[JimDawson]

Based on some quick research, I don't think a nmotion BOB will work with Mach4. The Mach4 website is very specific about what BOBs will work with Mach4. I also did some other forum searches and can't find anything that would indicate it's possible.

If you want to use Mach4, then I would recommend using one of the listed units on the Mach4 page.