- Joined
- Nov 9, 2012
- Messages
- 29
Been reading the site for a long time however i seldom post.
I have a Bridgeport clone (Summit) , that i purchased to start this machining adventure.
Table is 45inches long x 10in wide and knee appears that it will travel around 15inches.
Looking to purchase a 2 or 3 axis dro. Realisticaly what size scales should i be looking at?
Is it as simple as the full length and width of the table?
Or is there some other basic rule of thumb?
I have a Bridgeport clone (Summit) , that i purchased to start this machining adventure.
Table is 45inches long x 10in wide and knee appears that it will travel around 15inches.
Looking to purchase a 2 or 3 axis dro. Realisticaly what size scales should i be looking at?
Is it as simple as the full length and width of the table?
Or is there some other basic rule of thumb?