Looking at buying a ARNO Horizontal Mill, don't know anything about it. And can I fit a vertical head to it? If anyone can help me out I would greatly appreciate it.
We had an Arno mill in our shop about 1959. It had been used a lot when we got it. I came with a vertical attachment but was a "booger" to change. We used it for several years and the only problem we had with it was the clutch. Parts were not available then so we had to lap the clutch plates and re-fit. It was just a large clunky mill and we finally replaced it with a Bridgeport around 1972. Hopefully it is inexpensive!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.