Ball turner 2.

big o

Registered
Registered
Joined
Dec 27, 2013
Messages
44
Copied this design,with some minor changes. Different diameters
can be made by moving the center post.(piece shown is plastic).
 

Attachments

  • DSCN0066.JPG
    DSCN0066.JPG
    136.8 KB · Views: 75
  • DSCN0067.JPG
    DSCN0067.JPG
    136.1 KB · Views: 74
  • DSCN0068.JPG
    DSCN0068.JPG
    136.7 KB · Views: 71
  • DSCN0069.JPG
    DSCN0069.JPG
    136.6 KB · Views: 71
  • DSCN0070.JPG
    DSCN0070.JPG
    154.8 KB · Views: 69
  • DSCN0071.JPG
    DSCN0071.JPG
    151.7 KB · Views: 67
  • DSCN0072.JPG
    DSCN0072.JPG
    165.2 KB · Views: 62
Nice! One question how did you get the tool on center?
 
Shave the bottom to specs?
 
How does it swivel around when bolted to the cross slide? The post is in the same position in all the pictures.
 
Tool-post base was shaved. Mounting bolts to cross-slide are slightly loose to allow
base to pivot.
big o.
 
Back
Top