Bed length

The lack of steadyrest is not great but neither of them have one.
The 10K takes a 6K which I understand is not common collet but maybe a collet chuck is the way to go there.


Sent from my iPhone using Tapatalk
 
The lack of steadyrest is not great but neither of them have one.
The 10K takes a 6K which I understand is not common collet but maybe a collet chuck is the way to go there.

Neither will take a 5c collet, so yes. The spindle bore is small enought without a draw tube. A decent 4-jaw chuck can be had reasonably. Does the 3-jaw have both sets of jaws?
 
Neither will take a 5c collet, so yes. The spindle bore is small enought without a draw tube. A decent 4-jaw chuck can be had reasonably. Does the 3-jaw have both sets of jaws?
Good point on the draw tube, I didn't think about that.
Yes it does have both sets of jaws. I asked that specifically.


Sent from my iPhone using Tapatalk
 
Last edited:
Collet chuck, ER or 5C, would leave the spindle bore wide open while using collets.
 
Back
Top