- Joined
- Mar 26, 2018
- Messages
- 8,397
When I try to slide the T-Nuts on my Bridgeport 9X42 Table they get stuck in spots. I can't see the underside to know what is going on. I assume there are burs? These tight spots are in the center of the table, right where I need to tighten down my Rotary Table of the Chinese Vise.
I have watched a youtube where someone milled his own table with a t slot milling tool.
Ideas?
I have watched a youtube where someone milled his own table with a t slot milling tool.
Ideas?