Preload is already set within the assembly. All that was done was I put back together exactly the way I took apart. Marked inner races to shaft outer the same.
For the run in I hand spun for alittle to distribute grease. I have a vfd so I start with soft start ran it at 40hz for five minutes then increased to 50hz for another five and finally 60hz. Spindle has zero runout with a hub I’ll get between a half to a tenth. Very satisfied with the rebuild.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.