Bridgeport Vari-speed Puller For Motor Bearings

Brnoczech

H-M Supporter - Gold Member
H-M Supporter Gold Member
Joined
Nov 13, 2012
Messages
50
I posted this in the Bridgport forum, but thought I would put it here also. I am in the process of doing some maintenance on my 2J varispeed mill, and plan to replace the motor bearings. I have the motor off the mill, but don't have it disassembled yet. Does anyone know how long a reach gear/bearing puller I will need in order to reach the lower bearing on the motor shaft . I am guessing 7" reach or so, but does anyone know for sure. I plan to get the puller before disassembling the motor further. Thanks.
 
Thanks, however I was told that a splitter type puller would not work because it might bend or interfere with the "fins" that stick out at the end of the armature.
 
Ok, I guess that all of the ones we have done at work didn't work then? You need to get it apart and look to see what will work. Tim
 
Back
Top