- Joined
- Sep 29, 2017
- Messages
- 2,250
Since I bought my mill/drill it bothered me every time I wanted to lock an arbor or the drill chuck into place,but didn't have something to hold the spindle steady to tighten the drawbar. I used a spanner on the16mm squares that drives the arbor for almost a year, but slippage of the spanner started to round the corners of the squares so I had to make new ones and now HAD to make a c-spanner to fit.
I first made it to fit snug around the one side and on the other side just pressing against the square drive.
At first it worked well, but I realized (after I all ready been sprayed it) it is a bit of a problem fitting it every time. So I modified it for easy operation.
That's it basically. Thanks for viewing.
Michael
I first made it to fit snug around the one side and on the other side just pressing against the square drive.
At first it worked well, but I realized (after I all ready been sprayed it) it is a bit of a problem fitting it every time. So I modified it for easy operation.
That's it basically. Thanks for viewing.
Michael
