- Joined
- Jan 22, 2022
- Messages
- 128
I recently purchased a Clausing 8520. The seller forgot to give me the drill chuck and today I picked it up from him.
My 8520 has a Morse taper 2 spindle. This chuck has some sort of straight shaft and I haven’t tried putting it on my 8520 yet. I have been borrowing my MT2 chuck from my lathe.
Will this chuck be just as good as my MT2 chuck?? If not it appears to have a set screw holding the shaft. Could i by or modify a MT2 shaft and install on this??
My 8520 has a Morse taper 2 spindle. This chuck has some sort of straight shaft and I haven’t tried putting it on my 8520 yet. I have been borrowing my MT2 chuck from my lathe.
Will this chuck be just as good as my MT2 chuck?? If not it appears to have a set screw holding the shaft. Could i by or modify a MT2 shaft and install on this??