-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Collet question
- Thread starter fkrel
- Start date
OK I figured it out they are stark 32S 3 1/2 collets 24tpi threads made for the stark lathe with the closer and the draw tube. here is the page I found https://xtronics.com/wiki/Collet_Dimensions.html I have used a couple of them and they work very good in my atlas 10F.
- Joined
- Dec 25, 2011
- Messages
- 10,507
OK. I thought that I had just about every collet listing in captivity but this one has several collets that aren't on any of the lists that I had. Thanks. I'm glad that that question is now settled.
In case you haven't figured out what the columns headed Round, Hexagon and Square are, those are the largest size for each of those shapes that collets were made for.
I do notice that one dimension that could be critical in ID'ing an unknown collet closer adapter is not on the chart, and that is the collet head taper angle. Also, as long as the list is, it includes no metric collets.
In case you haven't figured out what the columns headed Round, Hexagon and Square are, those are the largest size for each of those shapes that collets were made for.
I do notice that one dimension that could be critical in ID'ing an unknown collet closer adapter is not on the chart, and that is the collet head taper angle. Also, as long as the list is, it includes no metric collets.
Last edited: