Hi Everyone, I am new to this site. I am looking all over the web but cannot get any assistance and sure someone had this issue before. I am building a CNC and running into a problem. The CNC run good but want to connect my Huanyang HY02D223B to the TB6560 3 axis blue controller board. The controller board has 3 connectors.
how do i connect this to the VFD connector panel. And how to set up with Mach3
This is the 3 pin outs on the Controller board
I am sure new builders will run into the same problems.
Bellow is photos of my CNC Build:
how do i connect this to the VFD connector panel. And how to set up with Mach3
This is the 3 pin outs on the Controller board
I am sure new builders will run into the same problems.
Bellow is photos of my CNC Build:
Last edited: