- Joined
- Apr 30, 2012
- Messages
- 2,401
I think the black wire was enable and you probably don't have the pins for enable turned on and assigned the correct port and pin in the "ports and pins"
"output signals" screen.
that would explain no motion with wire on and motion with wire off.
the always the same direction seems like a tuning problem.
I would remove the motors from the mill for x and y until you have them running right, it is easier to watch them without running to the end of travel.
I'll try to get out to my shed later
Steve
"output signals" screen.
that would explain no motion with wire on and motion with wire off.
the always the same direction seems like a tuning problem.
I would remove the motors from the mill for x and y until you have them running right, it is easier to watch them without running to the end of travel.
I'll try to get out to my shed later
Steve