-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
D1-4 Stud
- Thread starter randyjaco
- Start date
- Joined
- Jul 2, 2014
- Messages
- 7,594
Randy, you will also need to specify the threads on the stud. It is not part of the standard, and both metric and imperial thread are used for d1-4 tooling, perhaps multiple thread choices.
- Joined
- Jan 22, 2011
- Messages
- 8,031
- Joined
- Jan 22, 2011
- Messages
- 8,031
Once you find out what thread it is, let me look. I have a couple of pins I can check.
- Joined
- Oct 5, 2010
- Messages
- 1,043
Thanks guys, Global had them.
Warning to all, those studs are very hard. It doesn't take much of an impact or side loan to snap them off. I was lifting the Lathe with a bar in the chuck, the camlocks evidently were not tight. I was lucky that the Lathe wasn't off the ground when I heard the slap.
Warning to all, those studs are very hard. It doesn't take much of an impact or side loan to snap them off. I was lifting the Lathe with a bar in the chuck, the camlocks evidently were not tight. I was lucky that the Lathe wasn't off the ground when I heard the slap.