Diamond in the rough?

Thanks @Janderso, I'm very pleased with it.
From the overall condition of the lathe it's seen very little use. I'm inclined to leave the spindle bearings as they are. I will replace the felts however as that seems prudent.
I appreciate your concern and caution on my behalf, thank you :)
 
Looking at your spindle nose, I didn't realize that the 10K had a collet closer built in. I take it that you didn't get a collet drawbar set? I think that it takes 6K collets.
 
It does take 6K collets. Unfortunately no collets or the closer were included.
Not a huge deal to me as I think I would rather go with ER40 collets and an appropriate chuck.


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Back
Top