The DRO on my 1997 Enco 13x40 lathe is acting up. The X axis is not working. I have let the lathe get pretty dirty so I did try to clean & wipe off the area where the sensor runs with some solvent & a rag....but all I got was a reading that may jump from .008 to .009 regardless of how far I move the table (before the cleaning, it would only read .0000.
Is there any tricks to bring one back to life, or are the sensors one of those things that die after a while? How hard is it to find a replacement part?
thanks
Mike S
Is there any tricks to bring one back to life, or are the sensors one of those things that die after a while? How hard is it to find a replacement part?
thanks
Mike S