- Joined
- Jan 27, 2017
- Messages
- 184
I am planning the installation of a DRO (Sino SDS6-2V) on my lathe (PM1236). The literature indicates that the input voltage is 85V-250V and it appears that the power supply is internal (i.e. no black box plug).
Any reason why I shouldn't be able to direct wire to the lathe. I have seen this mentioned on other threads but wondered if there are any considerations that I should be aware of.
Thanks in advance for any input.
Mark
Any reason why I shouldn't be able to direct wire to the lathe. I have seen this mentioned on other threads but wondered if there are any considerations that I should be aware of.
Thanks in advance for any input.
Mark