- Joined
- May 13, 2019
- Messages
- 1,016
I'm looking to purchase a dividing head for my PM-25 mill. The smallest common size is BS-0. Is this too big for the PM-25 mill?
Assuming this size is okay, which brand should I get?
I see many listed on eBay for under $300 including shipping. Are they decent?
Then, there is the PM one for over $400 with shipping. I suspect this is a step up from the eBay ones.
Lastly, the Grizzly dividing head is over $500 without the chuck and without shipping.
I'd rather not deal with used since most seem to be missing parts and are of unknown condition.
Thanks!
Assuming this size is okay, which brand should I get?
I see many listed on eBay for under $300 including shipping. Are they decent?
Then, there is the PM one for over $400 with shipping. I suspect this is a step up from the eBay ones.
Lastly, the Grizzly dividing head is over $500 without the chuck and without shipping.
I'd rather not deal with used since most seem to be missing parts and are of unknown condition.
Thanks!