- Joined
- Oct 18, 2016
- Messages
- 2,872
I plan on making an idler pulley for my belt sander which will have a bearing pressed into it. OD of the pulley is about 2.125", with
a bore of 1.573". Width is a bit over an inch. I planned on an interference fit of .001". So, do I need to secure it with a snap ring,
or will the press fit suffice to keep the pulley in place on the bearing?
a bore of 1.573". Width is a bit over an inch. I planned on an interference fit of .001". So, do I need to secure it with a snap ring,
or will the press fit suffice to keep the pulley in place on the bearing?