Drill press pulley removal??

Drill and tap 2 holes in top of pulley such that a bar with matching holes can be placed across top of pulley with spacer to shaft.

Will pull directly on body of pulley without breaking

Sent from my SAMSUNG-SM-G930A using Tapatalk
 
Update: purchased a gear puller on Amazon for $10 and that did the trick! Didn't need to heat up the shaft or create any support for the pulley ring. It was on there tight, which I assume is why I could not pry it up at all from one side (before the gear puller). I just used a large diameter bolt to plug the hole and give the gear puller a point of contact. Thanks everyone for your help, another problem solved.
dp4.jpg
dp5.jpg
dp6.jpg
 
Back
Top