-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Drilling holes in the table
- Thread starter jmkasunich
- Start date
Too much stuff has followed me home from there
- Joined
- Feb 9, 2017
- Messages
- 5,242
See I’m such a heretic I drilled mounting holes in the almost pristine table of my UniDrill so I could mount my 8” rotary table/ Heinrich vise. It has two t-slots but they were not where I could use the for the RT. I love t-slots for drill presses but few have them for some stupid reason. The next best thing is drilled and tapped holes. Drilled and tapped holes are useful, not shameful. Being sloppy about work setup and drilling into a table is shameful. rant off…