I have an HXX GCS900-2DB DRO and cannot get into the settings function to change the type from MILL3 to LATHE2.
Without the type set to Lathe I can't get into Diameter mode - it is always in radius mode.
The manual says "Multifunction readout can be easily set to MILL,Grind,Lathe, EDM, etc.. Set the power switch to ON, press the key "A/I" six times until the right window displays the type, then press the up or down arrow to select the type."
This procedure does not work, the unit just completes the self test and then displays the usual x & y coordinates.
Some of these units have an "S" in the lower left corner that is actually a button switch to get into a setup area but on mine the "S" is just cosmetic - no button behind it.
I would sure appreciate any method ideas you may have to get into setup.
Forget asking the vendor - useless.
Thanks
John
Without the type set to Lathe I can't get into Diameter mode - it is always in radius mode.
The manual says "Multifunction readout can be easily set to MILL,Grind,Lathe, EDM, etc.. Set the power switch to ON, press the key "A/I" six times until the right window displays the type, then press the up or down arrow to select the type."
This procedure does not work, the unit just completes the self test and then displays the usual x & y coordinates.
Some of these units have an "S" in the lower left corner that is actually a button switch to get into a setup area but on mine the "S" is just cosmetic - no button behind it.
I would sure appreciate any method ideas you may have to get into setup.
Forget asking the vendor - useless.
Thanks
John