- Joined
- Feb 8, 2014
- Messages
- 11,138
I have a bunch of 3/4 tooling plate on the shelf. Mass in this case is not an issue, the mill or router won't even know it has anything on the table.
Cleaning filament. The reviews looked pretty good. https://www.amazon.com/CLEANING-Filament-Makerbot-MakerGear-Printers/dp/B00MVIYNFW
I do tend to lean towards overkill. I didn't want to undersize the heaters, it is always easier to run them at reduced power. That and I don't want to have to increase the size of my 24V power supplies, I'm running out of room in the electrical cabinets.
Cleaning filament. The reviews looked pretty good. https://www.amazon.com/CLEANING-Filament-Makerbot-MakerGear-Printers/dp/B00MVIYNFW
I do tend to lean towards overkill. I didn't want to undersize the heaters, it is always easier to run them at reduced power. That and I don't want to have to increase the size of my 24V power supplies, I'm running out of room in the electrical cabinets.