Only thing I'm curious about is my led lights are very dim. 24v + going to terminal 1 ground to terminal 2. Not sure if I reversed polarity that would make them brighter, or not work at all? The lights are led 22mm units from automation direct.
Pretty sure i ordered 24v leds. But ill check the invoice. The power source is the 500ma 24volt positive logic supply from vfd which is a danfoss fc51I think you wired them correctly. They are normally pretty bright. Two posibilities that I can see, maybe you ordered the 120V LEDs by mistake, or your 24V supply is not big enough to power the LEDs. What are you using for a 24V supply?