- Joined
- Aug 14, 2016
- Messages
- 21
jung4g, could you check to see which connections are wired on your emergency shut off switch. I thought I found the problem as one of the leads was very loose pretty much off. When I put it back on it didn't make a difference.
I'm assuming these shut off switches are NC (normally closed), the Grizzly manual isn't much help as it has a differnt type of switch, but it did look like NC. When I test it, the readings don't change. If it is NC I could temporarily tie the leads together to at least test if its the switch or not, but there are two other screws (a 3 & 4 on the other side)
If it's this then I would have to find a switch like this one some place..
I'm assuming these shut off switches are NC (normally closed), the Grizzly manual isn't much help as it has a differnt type of switch, but it did look like NC. When I test it, the readings don't change. If it is NC I could temporarily tie the leads together to at least test if its the switch or not, but there are two other screws (a 3 & 4 on the other side)
If it's this then I would have to find a switch like this one some place..