-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
End Mills 3/4, 7/8, 1 inch
- Thread starter gi_984
- Start date
4
4GSR
Forum Guest
Register Today
I have lots of 3/4" single end and double ends that have been resharpen on the flutes. Some my need touching up on the ends, most are okay as is. They are all from my dads shop from years past. If interested in a few of then let me know. Don't know if I have any 7/8" end mills, I do have some 1" that have been reground on the flutes and I have a few that are new. Ken
- Joined
- Jul 20, 2014
- Messages
- 1,386
You'll occasionally find some very good deals on Ebay; Niagra, Garr, Melin, Nachi, etc... for $30-$50 each for those sizes.
Normally, end mills that large go for over $100 each or more. May I ask what you use large end mills for? Would a fly cutter work?
Shell mill?
Normally, end mills that large go for over $100 each or more. May I ask what you use large end mills for? Would a fly cutter work?
Shell mill?
Using them in a mill with a NMTB 50 spindle. So much heavier cutting capacity compared to R-8. I've also got a 4 inch Sandvik shell mill for rapid removal of flat stock.
Still use fly cutters for nice surface finish.
Ken, shoot me a PM and we can discuss.
Emilio, looking forward to your project.
Chris
Still use fly cutters for nice surface finish.
Ken, shoot me a PM and we can discuss.
Emilio, looking forward to your project.
Chris