- Joined
- Aug 19, 2017
- Messages
- 126
Got the upper tube in place. Thought I had a small OD tube bender from plumbing days with flaring tool. no go there
Just bent them by hand. Rubber is 1/2" OD 1/8" ID , could have just ran a long piece and wire ties, but stayed on the plan.
Got the new tensioner pulley in so that's good to go.
No Vacuum layout diagram under the hood or anywhere.
Just bent them by hand. Rubber is 1/2" OD 1/8" ID , could have just ran a long piece and wire ties, but stayed on the plan.
Got the new tensioner pulley in so that's good to go.
No Vacuum layout diagram under the hood or anywhere.