Face plates

gonzo

H-M Supporter - Silver Member
H-M Supporter - Silver Member
Joined
Dec 19, 2016
Messages
211
I have several lathe face plates for trade plus other see below.

Lathe thread stop 2 3/4" across ways

Thread protector 2 1/4 - 8

Face plate:

1 3/4"- 8thd x 5"

2 1/4" -8thd x 6.5" plain face could be made for chuck back plate

1" - 8thd x 5"

1 5/8" - 11.5thd x 8" four t slots, four reg slots

2"-8thd x 6.5" one open slot

2"-10thd x 8" 6 t slots

I have a SB 9a lathe and a HF mill will trade for stuff I can use of equal value.

Photos on request.
 
PM me about things you'd trade for the 9" SB lathe. What condition are the ways in? How accurate will it turn a long bar ,meaning how much do the diameters vary along the length of the bar? I would like to see the photos. We are in the same state,at least!
 
George,
Sorry that I wrote my message in a subjective manner.
I only have the face plates and mentioned my equipment to illustrate what kind of tooling I might have a need for.
 
Sorry, I have no use for more face plates.
 
Back
Top