Good video. I seem to have solved most of my issues. The center drill probably was the big thing. I made a couple of tools on the mill using collets for the edge finder and the drill bits. Lots of collet changing. Way too much, in fact. But the results were there.
I also discovered that my new pricey vise had gotten out of square. Almost .100 over six inches! Took a while to get it back lined up and clamped down more securily. The slots in my table are 5/8, and the keys that came with the vise are .687. So the vise has no keys at the moment.
Anyway, thanks to all for your assistance. I'll be back soon with more problems, no doubt.
