I got two 5" Vises on my Lagun FTV1-S
They are not the same hight..
There is somthing like 0.20mm(0,008" ) hight different in the bottom of the jaw.
Is there a good way i can fix this on the mill? mill of the bottom of the 1 that is highest?
They are not the same hight..
There is somthing like 0.20mm(0,008" ) hight different in the bottom of the jaw.
Is there a good way i can fix this on the mill? mill of the bottom of the 1 that is highest?
Attachments
Last edited: