Foot stool

0

09kevin

Forum Guest
Register Today
My wife's foot stool lost one of the protective feet that keeps the metal frame from scratching the floor so I used the Taz6 to print up another one. It fit tight enough that I didn't need to use glue to hold it on. I printed it using PLA so we will see how it holds up!

29365950_10211739635391762_7987606432788774912_n.jpg
29432646_10211739635111755_5992041606318915584_n.jpg


Kevin
 
What software did you use for 3D modeling?
 
Nice job. 3D printers are so useful to make items like this which you could not purchase.

Even if it breaks you can easily print another one.
 
I'd hafta replace the other side too, for symmetry.
....and then maybe the other two back feet.
-brino
 
Back
Top