Does any one that has upgraded there G0704 have a power switch laying around? or know a part# to an aftermarket switch that will fit? I hate to pay $23.00 plus shipping that grizzly charges.
Well the switch isn't the pI think it is the controller board. It started out I had to hold the switch in foe a couple seconds before it would latch. But the motor started right up. Now the motor wont run and the switch won't latch, but the tac lights up and works if I spin the spindle by hand as long as I hold the switch in.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.