G0755 X axis power feed

Requires 220V, single-phase, 60hz, 15A power supply

Makes you wonder what kind of motor they're using. It only develops 135 lb/in of torque ... Hmmm.
 
Just the google look up page has some negative views on CDCO. I guess I'll have to see if anyone is using the Grizzly version.
 
Been looking around the web. It seems the Asong potentiometer is prone to crapping out. Any suggestions on other brands/vendors? Thank you...
 
Sorry about the link. I was trying to point you to the Align AL-500D. MSC has it but I can't copy that link, either. However, I will post the Google link and you can see if it works. There is a promo going on that will lower the cost by 30% but be sure it will fit your mill before jumping. Gotta' do some homework on this one, Aukai.

https://www.google.com/url?sa=t&rct...ils/41046715&usg=AOvVaw0EHdGuZNO5wgBlItwFPXw9
 
I bought my G0755 with the power feed. I use it almost everyday without issues.
Even though mine came with the machine & was wired. Installation looks pretty straight forward.
 
Thank you Mike, Sleddog, I'll check on the MSC in a bit.
 
Back
Top