- Joined
- Mar 10, 2018
- Messages
- 4
Hello all.
I just got a G0768 lathe and had a question on the power feed feature. I am try g to machine 6061 1 1/4" round bar and keep getting a record finish. My power feed is set at its lowest which is .0037" I believe. I have tried both hss and carbide both with the same results as well as different rpms. Any advice would be greatly appreciated.
Thanks krank
I just got a G0768 lathe and had a question on the power feed feature. I am try g to machine 6061 1 1/4" round bar and keep getting a record finish. My power feed is set at its lowest which is .0037" I believe. I have tried both hss and carbide both with the same results as well as different rpms. Any advice would be greatly appreciated.
Thanks krank