G4003g Ball Oiler

Seems to me the part should either be replaced or bore the hole out larger and build a bushing for the oversize hole to fit the oiler, just saying !!
 
Abrace, whatever happened with this?
 
They ended up sending me a new cast piece for the back of the tailstock. It took a lot of phone calls, follow up photos etc for it to happen as they didn't believe the hole was drilled oblong. They thought it must just be a small oiler in a big hole. Anyways, they made good on it at the end of the day. Probably took 3 weeks start to finish to get the part.
 
Last edited:
You must log in or register to reply here.
Back
Top