RF-30 mill, late 80’s, Taiwan manufacture. Needs upper spindle bearings, and will need a motor capacitor in the near future. Both of these repairs are relatively simple, and inexpensive. The bearing replacement is covered on this forum in a thread by Mikey. Otherwise in quite good condition, & complete. Includes owner’s manual. Powered, and runs. 110v.
Comes with a welded steel stand, 24x48x40 tall. No tooling whatsoever.
You come and get it. Need an engine hoist or similar to move, no stairs, or other difficulty.
Save it from the scrapper.
Fresno, Ca.
PM if you’re interested.
Comes with a welded steel stand, 24x48x40 tall. No tooling whatsoever.
You come and get it. Need an engine hoist or similar to move, no stairs, or other difficulty.
Save it from the scrapper.
Fresno, Ca.
PM if you’re interested.
Last edited:
