Hey Everyone, I have another question about the G0752. I was wondering what part of the bed/ways does the carriage actually slide on. On both ways there are a flat section, then there is the upside down V shaped section. I couldn't tell just by looking and I didn't want to take the apron apart just to make sure of what I thought. I thought the apron ran back and forth on top of the flat section so I always leveled the lathe according to the flat part. I noticed that the V part isn't level the same as the flat so I am hoping I am right in using the flat part with a couple 123 blocks to higher the level to level the lathe. Im sure a dumb question but with me replacing the spindle bearings and need to check the headstock alignment, etc I was leveling the ways and wanted to make sure I wasn't wrong . Thanks for any help on this. Warren