Well the time had finally came to move my new mill into the shop, but I have no idea how its wired right now. On the electrical junction box on the back theres a sticker that says 110V or 220V 1 Phase 4 wire. Which makes sense as the cord out of the back is a four wire cord to the wall. So I went to the motor on it and took the junction box apart on it and theres just 3 wires going to it, one ground wire, a white and a black. Not four wires. I have a 110v 20 amp plug right were I want to put the mill, question is how to I wire the motor to run on the 110V? Or should I get an electrician to come wire a 220V plug for me? The mill in question is a Craftex B048. Thanks all.