How best to lift & mount the 1340gt?

[Fallon]

I think you might be lacking some pegboard there behind the tool chest and drill press - just sayin'
One can never have too much pegboard & hooks/hangers...

I actually have a bit, just haven't gotten around to properly mounting it yet. We won't talk about how long it's been sitting there against the wall though.

 

[Firstgear]

I actually have a bit, just haven't gotten around to properly mounting it yet. We won't talk about how long it's been sitting there against the wall though.

Hopefully you will mount that peg board before you load it up and it tips over towards the lathe bed....just saying...

 

[Fallon]

Hopefully you will mount that peg board before you load it up and it tips over towards the lathe bed....just saying...

All that pegboard on the back wall is properly secured on 2' centers vertically. The couple sheets still unmounted just being stored behind the chop saw, not so much.

Sadly that's snow there on the ground that I swept off the lathe, toolbox & other stuff. As near as I can tell the blizzard blew it through the decent cracks in the barn door 35' to the back of the shop. A bit of rust on the lathe now. :-(

Before & after photos of lifted F350, 5 ton military truck, & some barns I helped dig out after the March 2019 Colorado blizzard. https://photos.app.goo.gl/oPhzFNLRrAhgZjro8