- Joined
- Aug 4, 2018
- Messages
- 5
Hi, my first post here. I'm a machining newbie but having a lot of fun learning along the way.
I have an aluminum box section motorcycle swing arm that I want to open the axle channel by 5mm to accept a larger diameter axle. I'm not sure how to go about suitably holding the piece for machining due to the awkward shape. The only way it will fit in my mill is by clamping one end to the table or securing in the vice but my big concern is chatter ruining the finish.
Any guidance, suggestions, alternatives greatly appreciated. Thanks.
I have an aluminum box section motorcycle swing arm that I want to open the axle channel by 5mm to accept a larger diameter axle. I'm not sure how to go about suitably holding the piece for machining due to the awkward shape. The only way it will fit in my mill is by clamping one end to the table or securing in the vice but my big concern is chatter ruining the finish.
Any guidance, suggestions, alternatives greatly appreciated. Thanks.