how to make

[taycat]

want to make puller in pic.
looking at it just bit of hex bar with end turned down and slit.
am i right?
best pic i could get.
don't want to be paying £20 for what could be a one of job.

 

[savarin]

I can see how the taper on the end of the bolt expands the mandrel to grip the inner bearing race.
Do you then have to pull on the central bolt to remove the bearing?
The central bolt looks like it came from one of these
http://www.ebay.co.uk/itm/THROUGH-B...-Rag-Type-M6-M8-M10-M12-M16-M20-/201382002994
Might make the job quicker.

 

[taycat]

got the rawl bolts.
was going to use slide hammer to remove it.

 

[savarin]

Looks like your well on the way.
Have a good one.

 

[taycat]

do you reckon it is just bit of hex bar turned one end and slit?
so all one pce?

 

[savarin]

Ha! found this, how to use that tool.
Its in four parts.
https://www.ebay.co.uk/itm/Bearing-...rst-Blind-Extractor-Puller-Tool-/131982079526

 

[taycat]

great and video.
add on ebay i looked at didn't have other pics or vid.
cheers

 

[Groundhog]

Pretty neat tool. Figures though -- $2 for the tool and $17 shipping to the USA!

 

[taycat]

find out what private shipping is.
can have it sent to me then i can send it on.

 

[magu]

Looks like something you could turn based on a premade concrete anchor....