Ok didn't get a whole lot done.
I squared up 2 blocks and drilled the connecting rod hole.
From there I put it in a 4 jaw on the lathe and turned up the little boss.
Then went back to the mill drilled the 2 0-80 screw clearance holes and proceeded to mill the block to what you see now.
What is left is the crank hole, radius's and general clean up.
Hope to get them done before the weather gets to nice to stay indoors
Been trying to take pic along with video when I remember.
Ok finished up the frame or base still needs some hand work though.
Got the flywheels also done.
Then I got distracted and played with my V-8 engines a bit. LOL
Well got a little done today between going and getting my pepper seeds and tomato seeds and starting soil. Tomorrow I plan on getting them planted in the starting tray.
So anyway I did get the crank done
also the slide valve and piston.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.