I have 2 holes that should be 17/32 on one end, 5/8 on the opposite end, hole is in 1/4" plate. What angle would this be? Can I buy a reamer that will do this? I've drilled the 2 holes 1/2" to start
That would be an included angle of 21º. You could have a reamer made for that, or you could chuck it in a four jaw chuck and bore them with the compound set at 10 1/2º.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.