info on angle

Mutt

Registered
Registered
Joined
Aug 16, 2014
Messages
366
I have 2 holes that should be 17/32 on one end, 5/8 on the opposite end, hole is in 1/4" plate. What angle would this be? Can I buy a reamer that will do this? I've drilled the 2 holes 1/2" to start
 
That would be an included angle of 21º. You could have a reamer made for that, or you could chuck it in a four jaw chuck and bore them with the compound set at 10 1/2º.

Edit: correct Half angle.
 
Last edited:
it's on a piece of 1/4" plate. They are detent holes
 
Back
Top