[4]

interesting tool holder

[3]
[10] Like what you see?
Click here to donate to this forum and upgrade your account!

davidh

Active User
H-M Supporter - Gold Member ($25)
Joined
Jan 23, 2012
Messages
1,216
universal lantern holder1 (600x800).jpgthis came in the box of stuff my father in law left for me with the craftsman 12" lathe. (not the c-clamp) seems to be a universal tool holder for left or righ hand tool holding, and with a swing- over clamping arrangment. . . . . seems folks were really trying hard to make the job easier and quicker, huh ? neat idea.

edited as the dog was bugging me when i was trying to type (90 lb german shepard puppy)

universal lantern holder1 (600x800).jpg
 

davidh

Active User
H-M Supporter - Gold Member ($25)
Joined
Jan 23, 2012
Messages
1,216
how would a fella bore to the right ? ? ? ? ? i just can;t get my head wrapped around that idea. . .
 

November X-ray

Active User
Registered
Joined
Jun 12, 2011
Messages
581
By rotating the lathe in the opposite direction with the tool on the far side of the bore!
 

Starlight Tools

Active User
H-M Supporter - Gold Member ($25)
Joined
Sep 22, 2010
Messages
794
Or drive the stock with a spider. Set spider legs inside the hole far enough past where the bore will end and support the other end of the stock with steady rest and or centre in tailstockand bore away.

Walter
 

KBeitz

H-M Supporter - Gold Member
H-M Supporter - Gold Member ($25)
Joined
Apr 17, 2018
Messages
475
They also come strait... I have two but this one the screw flips
all the way around so a bar can be put on top or bottom.
Really you keep the cutter on the top at all times. You just flip
the bar over. One V-grove is higher than the other...

DSC04354.JPGDSC04355.JPGDSC04356.JPGDSC04353.JPG
 
[6]
[5] [7]
Top