- Joined
- Nov 29, 2015
- Messages
- 439
What is the bare minimum speed of a a Diamond wheel setup? I swear the setup motor I've got is geared way down. So maybe too slow even at full speed? I've played with the controller to the point I think I've reached it's max frequency for this motor. But seems slow. I'm going to setup a Diamond wheel hone and have most of the parts already. Wheels/backing plate/controller/motor. Small bench top stand yet to be built But I have the steel. A Simple tilt table...only need 3 degrees so that might just be a fixed setup super simple.
I ran 220 over to my bench to run the controller so that part is in place...anyway. What RPM? I don't know if this gets up to 300 even. I can post pictures of the motor plate and gear box if that helps. Maybe I have the controller setup wrong?
Paul
I ran 220 over to my bench to run the controller so that part is in place...anyway. What RPM? I don't know if this gets up to 300 even. I can post pictures of the motor plate and gear box if that helps. Maybe I have the controller setup wrong?
Paul