- Joined
- Aug 1, 2022
- Messages
- 137
For future reference, a very good friend had one of these lying around and I managed to fit it onto my Rusnok Model 70 head.Tonset, any chance of sharing your replacement motor spec and dimensions of the new mounting plate?
Thanks.
I had to drill out the holes on the mounting plate to 3/8” (it was almost there, but I couldn’t quite put the 3/8” bolts through the plate) and I had to extend the motor shaft about an inch though.
I mounted the speed controller on the wall.
The motor is a PMDC motor with controller, p/n (1) 1F796H