Its Finally Up and Running

[Buffalo20]

I’ve been using the Rockwell mill quite a bit lately. I wasn’t really sure if I’d use it a lot, as it originally was bought to keep it out of a wrecker’s yard. I used it earlier this week to cut a series of 3/8” x 6” slots, in 6” x 8” x 1/4” steel plates, Plunge, then mill the full length in one pass, with a 3/8” 2 flute carbide mill. Six plates, three slots in each plate, so about 108” of slots, mill never sounded strained, and ran like a dream.