Jet 1236-ps Revisit

[jbobb1]

Will check tomorrow. Still wonder why there is not a hole 180 to the existing hole that is there. If pin sheared how would you drive it out.

This is a mystery.
The only thing I could possibly think is the lead screw has a through hole. In the event of a crash and a set screw pin type of thing were used and sheared, you'd hopefully be able to pull the lead screw and knock what's left of the pin out and replace it.

 

[DAT510]

Sorry for the delay... been wrapped up at work this week.

Here are some picts from my Jet-1024P. On mine, it is a set screw. Mine also has a brass bushing.







Here are some measurements of the pulleys as requested. Dimensions are in MM.



Hope this helps.

 

[Gman45acp]

Sorry for the delay... been wrapped up at work this week.

Here are some picts from my Jet-1024P. On mine, it is a set screw. Mine also has a brass bushing.


View attachment 295749View attachment 295750


View attachment 295751

Here are some measurements of the pulleys as requested. Dimensions are in MM.

View attachment 295752View attachment 295753

Hope this helps.

Thanks very much.