- Joined
- Apr 28, 2014
- Messages
- 3,590
Getting ready to re-purpose an old Kant-Twist #410 for Knurling.
Decided to created a 'real' drawing to go-by.
Scanned the actual clamp then traced it.
Quick & dirty, it's just the geometry - no dimensions. Should be close to within .010" - .015" Pivots are darn close.
Note 1:
Couldn't figure out how to upload to resources so I'm going to attach to this thread. Wouldn't allow .DWG or .DXF
Note 2:
Could only attach .DXF to this thread. If you want the .DWG give a shout out.
Decided to created a 'real' drawing to go-by.
Scanned the actual clamp then traced it.
Quick & dirty, it's just the geometry - no dimensions. Should be close to within .010" - .015" Pivots are darn close.
Note 1:
Couldn't figure out how to upload to resources so I'm going to attach to this thread. Wouldn't allow .DWG or .DXF
Note 2:
Could only attach .DXF to this thread. If you want the .DWG give a shout out.